Structural performance of waterproof pouring type bus duct:

1. The design adopts a scientifically reasonable "sandwich" phase line compact stacking structure to make the bus duct more compact and smaller, increase the dynamic and thermal stability of the working bus information system, and enable the bus to have both low impedance and voltage reduction technology advantages

2. The shell is made of unsaturated polyester synthetic resin and inorganic nanomaterials such as asbestos through integrated protection casting technology, with light stabilizers and flame retardants added to the resin. Metal casings can also be installed to increase the impact resistance and network lifespan of the working busbar system.

3. Adopting a "Y" - shaped waterproof joint, the connection is reliable and convenient.

Insulation configuration:

The insulation medium of waterproof pouring type busbar trunking mainly uses high-grade insulation material - polyester imide. The insulation level is H level, and the insulation aging life is over 50 years. It is currently one of the high-performance products among practical insulation materials.

be careful:

Fully enclosed resin cast waterproof bus duct is a non-metallic shell bus duct. The waterproof bus duct adopts a special formula of composite resin and quantitatively selected mixed learning materials to make high-performance insulation structural materials, and the copper bus is directly poured into the system for sealing. No air gap, no chimney effect, busbar burrs or overload will not cause short circuits. The insulation material design does not contain halogens, and flame retardants will not release harmful chemicals. The protection technology level of the shell is IP68, which can not only be waterproof, fireproof, and corrosion-resistant.

1. Out of town, it is made of inorganic materials such as unsaturated polyester resin and asbestos powder.

2. Light stabilizer and flame retardant are added into the resin to improve the anti-aging performance and flame retardant material performance of the working bus

3. Resin exterior walls can be developed for long-term use in outdoor and corrosive gas protection environments, and metal exterior walls can also be installed to extend the service life of enterprise networks

4. After installation and use, the busbar system does not require maintenance

5. The bus protection level is IP65

6. The busbar copper bar is insulated with polyimide (gold tape) and has an insulation level of H-grade waterproof. The conductor is made of composite insulation material poured as a whole, and the inter section connection is poured on site. After installing the bus duct, the system is protected. The rating can reach IP68 and can be used in harsh environments such as high humidity outdoors and cable trenches;